System 74 13 599
=> €/$

CDI ignition for SIMCA 8 (CEV) distributer 

solid state high output condenser discharge ignition (CDI) to be installed in CEV Simca 8 stock distributer housing. 2 twin gnition coils, converter and advance unit have to find a place elsewhere near the engine outside distributer

this is a ready to install kit, 

click pictures to enlarge them

• material is new and available
• solid state, con tactless ignition on hall effect basis with automatic advance control
• no problem any more with points and  govenor

• this material does not simply replace the points by a hall element leaving the stock govenor, stock ignition coil and distributer finger in place
• if offers a genuine CDI with nearly 40KV output and not only a transistor trigger for the stock coil.
• it is not based on a photo sensor which easily malfunction in conditions of of oil and dirt and it does not have any open printed circuit boards which corrode as you have in some other offers.
• it may be run on 6 or 12V batteries

• assembly instructions
• parts in the pack (Photo)
• technical wiring
• dimensions of 1 exit ignition coil
• dimensions of twin ignition coil
• dimensions converter
• dimensions advance unit

• empty stock distributer, including cutting the arms of the govenor to about 28mm diameter (see drawing left below
• enlarge wire exit hole to 9.5mm for new protective grommet for wire.

• place pre-assembled adapter unit into the distributer housing and fasten with 3 screws M4 using existing holes there (see drawing below right)
• Place rotor on distributer shaft (fasten only after having timed ignition)
  

• stock distributer
• modified distributer
• fitting the hall unit into the distributer