Powerdynamo brings new ignition & light 
to your classic bike

 

Instructions for adapter of Powerdynamo racing ignitions to MMB tachometer 2:1 
module 70 00 222 sp 
The module has not been tested for use with other tachometers, AS there are very many different tachos, we can not give any indication for suitability of other material. 


IMPORTANT:		 Please do read those instructions fully before starting work on your bike or any modification on the supplied system.
If you have no expertise for the installation have it done by an expert or at a specialist's workshop. Improper installation may damage the new system and your motorcycle. 
You have to use a 12V battery!
If you have access to the Internet, see those instructions online. You get larger and better pictures by clicking onto them. System list at http://www.powerdynamo.biz

The tiny module (without wires 9x28mm) has 3 wires.
  • brown for negative ground
  • red/white to connect to the red/white of the PD stator (running ti kill switch). Do not connect a battery here!
  • green to connect to green wire of MMB instrument
  • wire diagram (larger version)


only for Powerdynamo racing systems which have this rotor (with 2 magnets)

  
NOTE:
  • The adapter is ONLY for use with present MMB tachometers supporting a ratio of 2:1 
  • The Tacho will imperatively need a battery 12V as the ignition system does not provide any voltage
  • Please observe the instructions supplied with your Powerdynamo system and the MMB tachometer